ftimescanlookup
Decription:
An ftimescan is executed at every point of a lookupscan:
- Move motors to first positions of lookup table
- Execute ftimescan-like acquisition (npoints * acq_time)
- Move motors to second positions of lookup table
- Execute ftimescan-like acquisition
- ... to the end of lookup table ...
Detectors are started only at the beginning and configured with all points of the entire scan. When using one lima device, CAMERA scanning and LIMA accumulation modes are supported.
Parameters:
All parameters are the same as an ftimescan. It only adds the lookup parameter motor_lookup. motor_lookup is defined in the same manner in bliss standard lookupscan : a list of tuple of motor / positions array.
Example:
MANU [2]: ftimescanlookup.pars.motor_lookup = [(rot1, [0.1, 0.2, 0.3]), (rot2, [90., 95., 100.])]
MANU [3]: ftimescanlookup.pars
Out [3]: Parameters [redis-key=fscan_manu_ftimescanlookup_pars]
.acq_time = 0.1
.npoints = 10
.period = 0
.motor_lookup =
- rot1 : 0.1 0.2 0.3
- rot2 : 90 95 100
.start_delay = 0.1
.latency_time = 0.0
.sampling_time = 0.5
.scan_mode = TIME
.camera_signal = EDGE
.save_flag = True
.display_flag = True